- 1). Push in the connector on one end of the BNC cable to the matching jack on the back edge of the camera and turn clockwise until it locks.
- 2). Connect the cable on the other end to the jack on the monitor in the same manner.
- 3). Unscrew the two power connectors on the lower right corner of the camera's back edge.
- 4). Insert the wire with the white stripe on the end of the camera's supplied power adapter to the terminal labeled "GND" on the camera and connect the black wire to the terminal next to the GND terminal. Tighten the screws.
- 5). Set the voltage to local requirements by turning the switch on the bottom of the power adapter connected to the camera, then plug in the electrical cord to an outlet.
previous post