- 1). Park the machine on a hard, level surface and set the parking brake. Turn the key to the "Off" position. Raise the cargo box by lifting up on the handle on its right side. Remove the drive belt off the clutch by hand.
- 2). Remove the nut from the lower shock mounting screw behind the clutch. Slide the screw outwards away from the clutch, until the end of the cap screw is even with the axle-mounting tab; do not remove the screw.
- 3). Remove the cap bolt from the center of the clutch using the ½-inch wrench. Slide out the bolt and the washer and slide the clutch off the axle shaft. Lay the clutch on a flat workbench with the large disc facing down. Locate the setscrew on top of the clutch, with a marker; mark the location of the setscrew with the outer edge of the cam. Mark the location of the spring tab located in the movable sheave.
- 4). Use the three-jaw puller to pull the cam off the clutch shaft. Remove the cam, spring, and movable sheave from the shaft. Pull the clutch buttons free with the pliers. Press the clutch buttons by hands. Reinstall the movable sheave, spring and cam and align with the markings previously made. Install and tighten down the setscrew. Reinstall the clutch by following the instructions in reverse.
previous post
next post