Things You'll Need
Instructions
1Construct a drum magnet, which offers a more efficient way to extract a large volume of iron than passing a flat magnet over the sand. To construct the magnet, you'll need a length of 4-inch PVC pipe, some permanent magnets and some two-part epoxy cement.
2
Cut the 4-inch pipe to a length of about 12 inches using a hacksaw. Glue eight 1/2-inch cylindrical neodymium magnets to the inside of the pipe with epoxy cement, spacing them as evenly around the inside of the pipe as you can.
3
Check the polarity of each magnet before gluing it -- all magnets must be glued to the pipe with the same pole facing out. To check polarity, bring one magnet close to one that's already glued. If you feel a repelling force, turn the magnet around before gluing it. If you feel an attractive force, glue the magnet in that orientation.
4
Allow the glue to set until it's hard, then glue a PVC cap onto each end of the pipe using PVC cement. Drill a 1/2-inch hole through the center of each cap and pass a 1/2-inch wooden dowel through the drum so that it extends out from 4 to 6 inches on either side. Drill a 1/4-inch hole through one end and pass through a small length of 1/4-inch dowel to use as a handle for turning the drum.
5
Build a shallow tray out of plywood that has two sections separated by a wooden divider. Construct a holder out of plywood that will suspend the drum over one of the sections and about 2 inches from the divider. The holder needs to consist of two upward-facing forks that can support the dowel -- much like a rotisserie.
6
Suspend the drum in the holder and staple a piece of rigid but flexible plastic to the divider. The plastic should be long enough to rest securely on the surface of the drum, and it should be wide enough to cover the space between the end caps.
7
Begin rotating the drum so that the top is moving toward the plastic. Pour sand slowly on the opposite side of the drum while you turn it. The magnets will attract the iron filings onto the drum while the rest of the sand continues falling. When the filings reach the plastic, it will scrape them off the drum and they'll collect on the other side of the divider.