- 1). Unsolder one leg of the diode if it is part of a circuit, otherwise the other components in the circuit may affect the results of the test. Heat the solder pad around the diode leg until the solder is molten, and then gently pull the leg through from the other side using pliers. Soak up any excess solder with desoldering braid, leaving the hole clear.
- 2). Set the multimeter to its diode test mode, denoted by the circuit symbol for a diode which looks similar to an arrow. If the multimeter does not have a diode mode, set it to the lower end of the resistance range.
- 3). Place one probe from the multimeter on to one of the diodes legs, and the other probe on to the other leg. Note the reading obtained, and then swap the positions of the probes and note the new reading.
- 4). Interpret the results. If you get an open circuit in one direction indicating the current is blocked, and a low resistance reading in the other direction, the diode is good. If there is an open circuit in both directions, the diode has failed with an open circuit. If there is a low resistance in both directions, the diode has failed with a short. In both cases the diode should be replaced.
previous post