- 1). Power off the Linksys WRT150N router. Unplug the AC adapter, and all network and modem cables connected to the router.
- 2). Extend the arm of the first antenna until it points straight out from the rear of the router so that it is not pointing upward. Twist the base of the antenna counter clockwise to unscrew and remove it from the router. Remove the second antenna in the same manner.
- 3). Align the threaded end of one of the high-gain antennas with the screw hole from which you removed the first antenna. Insert the threaded end into the screw hole and twist the antenna base clockwise until tight and secure.
- 4). Insert the second high-gain antenna into the second hole and tighten it. Adjust the angle of both antennas to point so that they points toward the areas where you use your wireless connected computers.
- 5). Reconnect the AC power adapter cord and the cables from the computers and modem. Power on the WRT150N router. Use the router and connected computers as you normally would.
previous post
next post