Simple Mini Bow

• 1). Cut the ribbon in half, than cut the halves in half. You should have four equal pieces of ribbon.
  
  
• 2). Take one piece of ribbon and bring the ends to the middle. Fold the piece in half so you have two loops. Stick a straight pin through the folded ribbon to hold it in place. Repeat this with a second piece of ribbon.
  
  
• 3). Wire the two pieces of ribbon together to make a bow. Remove the straight pins.
  
  
• 4). Hot glue the pearl string in the middle of the bow. Hot glue the bow to a barrette or clip. Repeat this process using the third and fourth pieces of ribbon to make a second bow.
  
  

Korker Bow

• 1). Wet the ribbon and tightly wrap it around the wooden dowel. Clip the ends with clothespins to hold the ribbon in place.
  
  
• 2). Place the dowel in a 250-degree oven for 20 minutes. Cool the ribbon, pull it off the dowel and cut the ribbon into 3-inch pieces. Lightly run a lighter flame over each end of the ribbons so they don't unravel.
  
  
• 3). Stack eight of the curly ribbon pieces together and tie them with a piece of thread.
  
  
• 4). Cut a piece of ribbon the same length as the alligator clip. Hot glue the ribbon to the clip. Hot glue the korker bow in the middle of the ribbon-covered clip. Cut a small piece of ribbon and hot glue it around the middle of the bow, wrapping it under the top of the clip.