- 1). Measure your wrist and make a note of the length. Cut a piece of the yarn 4 inches longer than the length. This is to allow for a knot to be tied before and after each bead and enough yarn to tie the two ends together on your wrist.
- 2). Place the yarn on the table and position the beads against it. The aquamarine bead should be positioned in the center of the yarn with the chrysocolla and then the rose quartz to one side of it and the black onyx and white quartz to the other side.
- 3). Make tiny marks on the yarn next to the center of the beads allowing enough yarn for tying knots.
- 4). Tie a knot (or a double knot depending on the size of the bead hole) just above where the rose quartz bead will be placed and pull the yarn through the rose quartz bead. Tie a knot again.
- 5). String the rest of the beads in the given order tying knots in between each, including the last bead. Make the knots big enough to keep the beads securely in place.
- 6). Tie the bracelet around the wrist to test for size. Trim off any extra yarn. Secure the ends of the yarn by tying a knot at each end.
previous post
next post