- The pipe, which runs down the length of the well hole to the bedrock can often be a source of problems. Sections of pipe can be pulled up and removed if they are cracked or leaking. Many times, pipes can be replaced by removing just the broken section and fitting it with another pipe.
- Electrical problems may also be the source of your well pump problems. If your pump is not operating, there may be a problem with wiring inside the pump or in the circuit above ground. First, flip the circuit breakers to see if that solves the problem. If not, the circuits may be blown and should be replaced. Wiring to the pump can also be checked for problems by using a voltmeter to check the resistance readings. This is also how technicians find out if a well pump is faulty. They will attach a voltmeter to the wiring leading down to the well and read the resistance levels. If they are too low or non-existent, then the motor is bad and must be replaced.
- Sometimes a well can lose prime. By removing the pitless fitting or priming plug which is located a few feet down inside the well hole, you can see if the well is at least drawing water. If there is water in the pipe, it means the pump is producing some pressure. If not, the well must be re-primed.
previous post
next post