- 1). Cut a piece of ¼-inch aluminum rod with a hacksaw. Cut the piece between 6 and 10 inches long.
- 2). Place four band clamps around the original handle. You need two clamps on each side of the break.
- 3). Slide the aluminum rod between the handle and the band clamps, then center the aluminum rod over the break in the handle.
- 4). Slide two band clamps so they rest approximately ¼ inch away from each end of the aluminum rod and slide the other two clamps so they rest approximately ¼ inch away from the break in the handle.
- 5). Tighten all four band clamps in place with a screwdriver.
previous post