- 1). Measure 1 1/4 inches of the 24 gauge wire with the ruler. Cut the wire to this length with the wire cutters.
- 2). Insert one end of the 1 1/4-inch wire into one end of the 24 gauge metal chain. Bend 1/2 an inch of the wire by using the needle nosed pliers. Wrap the wire around itself two to three times.
- 3). Insert 1/2 an inch of the other end of the wire into the loop on the pendant. Bend 1/2 an inch of wire with the needle nosed pliers. Wrap the wire around itself two to three times.
- 4). Cut the excess wire connected to the chain. Cut excess wire connected to the pendant.
previous post
next post