- 1). Turn the Verro "OFF" and unplug the power cord from the electrical source. Turn the Verro over and place it on a towel to protect the top of the machine.
- 2). Push the two locking tabs on the bottom of the unit toward the sides of the Verro to unlock and remove the panel on the bottom of the Verro. Lift out the filter bag assembly and remove the filter bag from the support bars.
- 3). Turn the filter inside out and use a hose to rinse the filter clean, gently shaking and squeezing the bag until the dirt and debris is removed and water runs clear. Invert the filter bag so the shiny side is on the outside and reattach to the support bars.
- 4). Place the filter assembly unit back in the Verro and replace the bottom cover.
- 5). Remove the jet valve port screws and take off the jet valve. Look at the impeller for any string, fiber or hair that may be caught in the impeller. Use a small hook or scissors to remove any fiber or hair. Replace the jet valve port and screws.
- 6). Check the tubes on each end of the Verro for any obstructions. Rinse clean with water.
- 7). Turn the Verro back over and rinse the exterior with the hose. Set the Verro in a cool, dry place to dry.
previous post