Transforming from Vehicle to Robot Head.

• 1). Fold the rear section of Mixmaster's cement truck form down revealing the robot's head.
  
  
• 2). Rotate the rear of the cement truck underneath the wheels and press until the piece locks in place.
  
  
• 3). Fold the top of the cement truck Mixmaster forward toward the hood of the vehicle.
  
  

Attaching the Robot's Head to the Body.

• 1). Fold the cockpit of Scavenger back 90 degrees.
  
  
• 2). Separate the top of Scavenger's vehicle form and rotate the halves down 45 degrees.
  
  
• 3). Fold the crane portion of Scavenger's vehicle form up and into the cavity created in the previous step.
  
  
• 4). Flip Scavenger upside down, aligning the vehicle's treads parallel to the ground to form the robot's chest.
  
  
• 5). Press the pegs on the bottom of the robot's head firmly into the corresponding holes in the robot's chest, between the vehicle treads.
  
  

Attaching the Robot's Feet to the Body.

• 1). Fold the bottom of Long Haul's dump truck out and rotate the bottom wheel casing 180 degrees.
  
  
• 2). Rotate Long Haul's vehicle cab back 30 degrees and rotate the back of the dump truck back 45 degrees to form the right leg.
  
  
• 3). Separate the bottom of Rampage's vehicle mode from the top and rotate the bottom section out 45 degrees.
  
  
• 4). Flip Rampage's treads forward 180 degrees and rotate the front of the vehicle form back 45 degrees to form the left leg.
  
  
• 5). Press the pegs on the right and left legs to the corresponding holes on the bottom of the robot's chest.
  
  

Attaching the Robot's Arms to the Body.

• 1). Separate the shovel on Scrapper's vehicle mode forming three separate shovel pieces.
  
  
• 2). Rotate the outer two shovel pieces up 90 degrees and rotate the front of the vehicle 180 degrees clockwise. Rotate the outer portions of the shovel forward 180 degrees to complete the right arm.
  
  
• 3). Fold the crane portion of Hightower's vehicle form back 45 degrees. Flip the treads up to the side of the vehicle cab 45 degrees.
  
  
• 4). Extend the lower portion of the vehicle out and collapse the treads completely underneath the vehicle mode to complete the left arm.
  
  
• 5). Insert the pegs on the arms to the corresponding holes in the robot's chest.