- 1). Draw two rectangles from the poster board. The rectangles need to be eight-inches long and five inches wide. Cut the rectangles from the poster. These are the front two top teeth.
- 2). Draw two smaller rectangles from the poster board. These rectangles should be six inches long and three inches wide. Cut these rectangles from the poster. These two teeth will surround the two front teeth.
- 3). Draw six more teeth. Make two of those teeth look like fangs. Make them ten inches long and shaped long thin triangles. Draw the other four as rectangles. The rectangles should be three inches wide and six inches long.
- 4). Spray-paint the wooden dowel black in a well-ventilated area. Allow the dowel to dry before using.
- 1). Open the trunk. Remove any items from your trunk that you do not need. You want the trunk's interior to be smooth and easy to plunder.
- 2). Push the center of the sheet back into the open trunk gently. Lay the wooden dowel in the trunk at the back. This will hold the sheet back.
- 3). Fluff out the remainder of the sheet in the bed of the trunk. Spread it out so that the entire trunk is covered.
- 1). Attach the two front teeth to the inside top of the trunk. Use duct tape to put the teeth in place. Place the two other front teeth on either side of the two front teeth. Tape them all to the sheet.
- 2). Tape a row of three teeth on each side of the bottom trunk. Use tape to attach the teeth to the inside of the trunk. Place a fang at the center of each row.
- 3). Turn on the parking brakes of your car to make creepy eyes and give your trunk a complete face.
previous post
next post