- 1). Fit the pre-made corners into the corners of the room. Apply vinyl adhesive to the back side of the pre-made corner molding by squeezing beads along the surface. Drag a notched applicator over the back side of the pre-made corner molding to spread out the beads of adhesive into a textured adhesive surface that covers the back side. Make sure the corners are fitted tightly against the floor and wall surface.
- 2). Roll the cove molding out along each wall. Cut the molding so that it is flush against each end of the pre-made corner pieces using a straight edge and utility knife to score the back side of the molding several times until it is separated.
- 3). Apply vinyl adhesive to the back side of molding by squeezing beads of it along each length of molding. Drag a notched applicator over the back side of the molding to spread out the beads of adhesive into a textured adhesive surface that covers the back side of the molding.
- 4). Fit each section of molding in place around the base of each wall and press it firmly in place. Rub over the molding with your hands to ensure a tight fit against the wall and floor surface.
previous post
next post