- 1). Attach the scope rings to the body of the handgun scope with the Allen wrench but do not completely tighten the screws; the scope should be able to move.
- 2). Loosen the scope ring mounting screws (at the base of the rings) and widen the mounting brackets.
- 3). Place the scope rings on the Weaver mount with the mounting screws set into the slots of the Weaver base. Align the mounting brackets on the sides of the Weaver base and tighten the screws.
- 4). Rotate the scope so that the cross-hairs appear straight up and across when viewed.
- 5). Tighten one set of screws and re-check the scope position. Re-adjust if necessary.
- 6). When you're satisfied with the scope position, tighten the remaining screws.
previous post
next post