- 1). Look under the seat onto which you want to install the Jeinko mount for a metal seat bolt.
- 2). Remove the bottom latch from the Jeinko mount -- twist it to free the bottom latch. The latch has a small, circular lift on the free end. Slide this into the opening on the metal seat bolt. The circular lift slides up through the opening in the seat bolt.
- 3). Place the Jeinko seat mount onto the lift you just slid into the seat bolt, then twist the mount until it is tight.
- 4). Turn the knob in the middle of the Jeniko mount until it is loose. Lift up on the mount tray (where the laptop sits) until it is at a comfortable position. Turn the knob to tighten it back into place.
- 5). Place the provided Velcro strips onto the bottom of the laptop computer. There is one side that has a tape-based adhesive on it. Stick this end against the bottom of the laptop, then push the laptop down onto the mount. This secures the laptop into position on the Jeniko laptop mount.
next post